To date, the market has a large selection of warm floor. The most acceptable in price are sets based on a heating cable.
This system is mounted as follows: the cable is laid on the floor and poured with a screed of sand and cement, a layer thickness of 3 to 5 centimeters. If the floor is planned to be covered with tiles, then it is necessary to add another 1 centimeter to this thickness. As a result, the floor level will increase by 5 centimeters. The screed is poured over the entire area of the floor.
In houses with a low ceiling, this type of installation of a warm floor will not work. During the installation of a warm floor with a heating cable, the volume of work is very significant.
Monting this type of warm floor, thermal insulation is used, which reduces heat leakage from 20% to 37%.
When installing such a sex in the garage or in the premises located above the basement, plate of polystyrene or foam foam or foam, from 30 to 100 mm thick, which are covered with a layer of polymer film or foil, should be used.
The requirement that is presented for thermal insulation is the heat conduction coefficient of 0.05 W/m*?WITH.
The disadvantage of such installation includes a long stream streaming. Its complete hardening for about a month.
You are interested in the toolkport tool, go to the site: