How to fix a ceiling skirting board?
Ceiling polyurethane foam plinth is an excellent modern material for decoration. In its appearance, it is similar to an expensive stucco molding, which not everyone can fulfill. But the ceiling plinth is not expensive. Glue this product after putting the surfaces is performed. The surface of the ceiling should be stain after such a plinth is glued.
First you should cut out the inner angle. There are two options for this: try to perform the joint perfectly with a hacksaw with small teeth, or with the help of a knife, remove the inner part of the corner. If you have a corner of not 90 degrees, then you should do the following: in the corner you need to put a newspaper or soft paper, burn around the corner, cut the lazy and fold in half. The cut line will show the cut line. Before you purchase a end-pipe, you will need to use this method. After you purchase it, it must be used everywhere where it is possible. Cut the return part of the corner. This will be the second plinth bar. At this stage, nothing should be glued.
If you are interested in NVF production in Moscow, visit the site. Only there you can order the best facade systems at a reasonable price.
From the edge of the planks, the chamfer should be removed and in the future fill it with putty. It will be necessary to apply glue to two plinth planks. Apply should be close to the inner corner. It is necessary to ensure that the strip is quite even, without any formations of drops or influx. By the time you will adhere to the 3rd skirting board, an understanding will come, to hold the tube properly, so that the strip lies as smooth as possible. Next, you should warm the glue on just in the sun or on the battery, before applying it in work. From this procedure, its fluidity will become much better.
After applying glue, the product is mounted in a corner. This sticker will be preliminary. After it is carried out, it should be torn off. Do not pay attention to the threads of the glue that will hang. They can be cleaned later. Wait a couple of minutes, the glue should dry. After that, you can glue it completely. On the skirting board should not be crushed. Pit can appear from the fingers. It will be very difficult to get rid of them in the future. Do not press the skirting board into the hollows of the wall, if they are a curve. Try to let it go as a maximum smooth arc.
You can leave a comment.