Installation of the water supply in the house should be performed before plaster and screening work. But it can be laid after these works, but then you will have to add concrete on the floor, and plaster on the walls.
It is better to choose the first option of course. Installation of the water supply in the house, the case is responsible. First you need to draw up a diagram of the water supply in the house on paper. Then the consumer material is measured and calculated: pipes, connectors, knees, couplings, taps, and t. D. If you need pipes for water supply, you will find them on the Polimer-Russia website.
Also, pumping stations, non -interrupted water supply are popular in private houses. When choosing the station, it is necessary to take into account the depth of water lifting, which is proportionally reduced depending on the removal of the tank, or well. The water station must be placed near the water source.
For this, in a private house, they usually build a small room where the station is installed. It is important that the work of the station does not interfere with you in ordinary life, and the water does not freeze in the water supply tank, and in the station itself. Installation of the water supply in the house, now they are made of hard -pro -proofs, by soldering them with a special soldering iron.
To supply water to the house, we take a pipe 25-30 mm, and for wiring in the house we take a 20 mm pipe (this is for a private house). Next, we drip a trench to supply water to the house from its source. In this case, we take into account the depth of freezing of the soil in your region. Installation of water pipes on the street, is carried out in plus weather. A heater is put on top of the pipe.
Then we put the pipe in a dug trench and fall asleep with soil. On the finished base under the water supply station, the station itself is installed. It is attached to the wooden base for concrete using dowels, and 3-5 mm rubber lining, for extinguishing vibration noise from the operation of the station. Be sure to install the check valve at the pump station.
This valve is necessary so that the water does not go back, and the station’s work is not violated. Inside the house, plastic pipes are carried out into the kitchen, in the shower (bathroom), bathroom, etc. D. First, we mount a ball crane on the pipe, at the entrance. This is necessary in order to ensure the possibility of emergency disconnection of the water supply, with problems. If necessary, install the water meter. Good installation to you.