Not everyone can make installation of a stretch ceiling with your own hands, since you need to either have experience of such a thing here, or be able to correctly understand the recommendations that professionals give, but for this you need to understand at least a little in construction and repair in general. If you are an absolute beginner, you have never dealt with the repair and think that a spatula is some kind of eastern dish, then it is better to pay money to professionals, so that they perform the installation of a stretch ceiling for you. Otherwise, you risk spoiling the canvas, which may entail more significant costs.
We mount stretch ceilings ourselves
It is recommended to engage in the installation of suspended ceilings independently only if there are no pipes leaving the ceiling in your room, and the room itself is of the right geometric shape. If the room has a lot of pipes, wires and all kinds of communications, and in addition to the full of protrusions and niches, then it is better to abandon your own installation, since in this case it is important to take into account the mass of the nuances and it will be about fourteen times easier.
So, suppose we are dealing with a standard rectangular room without hollows and any complications. In this case, a specialized profile or just a baguette will be used to attach the canvas. First, apply marking. After all, it is necessary to do so, so that the ceiling is located strictly horizontally, otherwise it will still have a vidok that. Ideally, use the laser level, but at worst the usual water. By the way, marking using a laser to perform a mess is easier than using a hydraulicarian.
Next, go to the fasteners of the baguette. If necessary, we can lower the ceiling as much as necessary, but it is not recommended to fix the baguette close to the ceiling – it will be very inconvenient to fix the canvas. When the baguette is fixed, you can proceed to the most important final stage. The canvas should be unpacked extremely carefully, so as not to damage it. Typically, the manufacturer puts an instruction in the package in which the basic angle is indicated, with which the correct location of the canvas is determined. Next, we fix all the corners of the canvas on the clamps and begin to heat the air in the room, so that the canvas becomes elastic and freely stretches.
Then, from any corner, a centimeter by a centimeter begin to refuel the edges of the canvas in the baguette. After the completion of this procedure, it remains only to mount the chandelier or lamps. To do this, be sure to use amplifying plastic rings, which must be glued to a special glue.
Video on the topic: